< Back
LFO Module
LFO Module

Outta Bass has two LFO’s which can be assigned to any attribute of the voice.  Each voice applies a simple AHD envelope which allows for the manipulation of the LFO over time.

Controls

LFO1
  • LFO1 Assignment – the voice parameter that will be modulated.
  • LFO1 Waveform – the LFO waveform
  • LFO1 Rate / Intensity – the rate (0.01Hz to 15Hz) and Intensity (0% – 100%) of the LFO
LFO2
  • LFO2 Assignment – the voice parameter that will be modulated.
  • LFO2 Waveform – the LFO waveform
  • LFO2 Rate / Intensity – the rate (0.01Hz to 15Hz) and Intensity (0% – 100%) of the LFO

Tips:

  • You can assign both LFOs to the same parameter and it will be modulated by both.
  • You can sync the LFO rate with the current tempo by turning on ‘snap’ in the Key & Tempo module.

Traps:

  • If the LFO envelope has a high attack value, it may appear as though the LFO is not working as it will take some time for the envelope to open.

 

Assignments:

The LFO can be assigned to these voice parameters:

Levels

  • Voice Level
  • Centre Osc Level
  • Side Osc Level

Pitch

  • Voice Pitch
  • Center Osc Pitch      
  • Side Osc Pitch 

Waveform

  • Center FM Multiplier
  • Center FM Intensity
  • Side FM Multiplier    
  • Side FM Intensity  
  • Side Width

Waveform Envelope

  • Attack
  • Hold
  • Decay
  • Sustain
  • Release

Filter

  • Cutoff Frequency
  • Resonance

Filter Envelope

  • Attack
  • Hold
  • Decay
  • Sustain
  • Release